| |
FEATURED BLOG
Update
Submitted By: Q
8/6/2009 8:28:27 PM
Not much new, found some new tools to lower costs.....
Automated die design has come a long way.. sort of on hold right now in lieu of putting some time in on other projects, but it is up and running....
Patriot tooling systems is the latest project.... allows a low cost tool to be built with more rigidity than older methods, and 10-13% price reduction... finding more things we can do with it too... it helps enable ...(more)
|
 |
|
| Blog Blogs and more Blogs...... |
| Submitted By: Bob Quinn on 10/3/2008 8:02:00 PM |
|
|
To those that are new to this site, I pose a question: I have long wanted to find a forum, a place where tool & die machinists, designers and business owners could collaborate and quiz each other for tips and general tool & die type topics. I have not found this sort of site. I found one at one time that was EDM.com dealing strictly with EDM machining and it proved quite useful, until a bunch of yahoos goofed up and started slamming different edm makes causing the site owner to tire of policing it. So it was shut down.
I have seen other sites dedicated to the tool & die industry but none ever seemed to take hold and generate enough interest to draw people back.
So my question is this: Are there others out there that would like such a site? And if so do any of you have any suggestions for a format?
Please direct any comments to my personal e-mail address bob@rcmtool.com
Thanks for your help!
Also, check out the new Tool and Die Authority column sponsored by PMA...... (I have been blessed with being chosen to be one of the contributing authors)
http://www.metalformingmagazine.com/toolanddie/ |
|
|
|
|
|
|
|
|
